5-minute engine flush Hi-Gear Motor Flush

Hi-Gear Motor Flush removes carbon deposits from the passages of the lubrication system and from the internal cavities of the engine, making it possible to clean the engine radically.

Advantages

It is guaranteed to remove carbon, sludge and deposits from the passages of the lubrication system and the internal cavities and improves oil circulation and heat removal from the engine parts.It helps to create a continuous oil film on the engine parts by removing varnish and non-wettable deposits.It restores the mobility of the oil scraper and compression rings.It is safe for rubber seals, oil seals and valve stem seals.It contains special additives that create an emulsion which envelops the particles of wear products, carbon and deposits and prevents their contact with the engine parts.It is compatible with all types of oils and engines, including turbocharged ones. Application

Warm up and switch off the engine. Pour the flush into the oil filler neck in accordance with the stated proportions. Start the engine and let it run for 5 min. at idle (heavily contaminated engines 10 min.). Switch off the engine. Drain the oil. Replace the filter and fill in fresh oil.

4-cylinder engines:

for a scheduled oil change on engines with a mileage of up to 70 000 km, it is enough to use 450 ml of the product;for flushing heavily contaminated engines use 630 ml of the product and flush for 10 minutes. 6-8-cylinder engines:

for engines with a displacement of more than 2.5 l and a lubrication system of more than 4 l use in the proportion: 160 ml of the product per 1 l of oil. In this case it is necessary to make sure that while the flush is being poured in, the maximum oil level in the sump set by the manufacturer is not exceeded.